Used to break loose old valve bodies and cut copper or galvanized supply lines cleanly before new rough-in.
Shower installation longview WA built to last decades
If your shower leaks, looks dated, or never gets hot enough, we handle shower installation longview WA from tear-out to final caulk line. We serve homeowners across Cowlitz County with walk-in conversions, pan replacements, and full valve upgrades.
Serving longview and nearby areas.
How big is the job?
Full rebuild
New pan, drain, valve, and waterproofing with the layout staying in place.
- 1. Panel swap Replace the surround and valve while keeping the existing pan and drain.
- 2. Full rebuild New pan, drain, valve, and waterproofing with the layout staying in place.
- 3. Layout change Move the drain, reframe the opening, or convert a tub to a walk-in.
Drag the needle to compareTouch and drag the needle
- 30Services from one local team
- 20Areas served around longview
- Camera firstWe look inside the drain before quoting.
- Flood testThe pan holds water before walls close.
What our shower installation includes
Every shower installation starts with a written scope so you know what is covered before we cut anything. Standard work includes tear-out, rough-in, waterproofing, and finish.
Work order
Shower Installation- Tear-out and disposal: We remove the old surround, pan, valve, and any failed backing, then haul it all away. Floor protection goes down before the first hammer swing, and we bag debris as we work so your hallway stays clear.
- New valve and supply lines: We install a pressure-balanced or thermostatic valve from Moen, Delta, or Kohler and run new PEX tubing or copper pipe to it. Every joint is pressure-tested before the wall closes, so a hidden drip never becomes your problem.
- Pan, drain, and waterproofing: We flood-test the pan and confirm slope with a level, which is what keeps water out of your subfloor for the life of the shower.
- Finish surfaces: Tile or acrylic panels go up over the waterproof layer, with silicone at every corner and penetration. We set the trim, shower head, and any grab bars into blocking so they hold weight safely.
- Final test and cleanup: We run hot and cold water, check for leaks at the valve and drain, and confirm the pan drains fully. You get a walkthrough of the shutoff and care steps, and we leave the bathroom ready to use.
What the first visit covers
First visit
We measure the shower, camera the drain, check pressure, and leave you a written scope.
Shower work for Longview homes
We install and replace showers in houses across Longview and Cowlitz County.
Low pressure
Valve and cartridge replacement with a pressure test.
Tub to shower
Convert a tub wall to a low-threshold walk-in.
Cracked tile
New tile over a waterproof layer with sealed corners.
Shower work for Longview businesses
We handle shower installs in rental units, gyms, and small lodging properties.
Rental units
Durable panels and common valve models.
Gyms and locker rooms
Heavy-duty valves and drains for daily use.
Small lodging
Fast turnarounds between guest stays.
What shower installation longview WA actually involves
A shower is a wet room, and water always finds the weak layer. Doing the pan, drain, and membrane correctly the first time is what keeps the floor dry and the framing sound.
Shower installation longview WA is the removal of an existing shower or tub surround and the rebuild of the waterproofing, drain, valve, and finish surfaces into a working shower. It is needed when a pan cracks, tile fails, a valve seizes, or you want a walk-in layout that fits how you actually use the bathroom. The work touches framing, PEX tubing or copper pipe, a new drain assembly, and a waterproof membrane behind the tile or acrylic panel. Skip any layer and you get rot, mold, or a slab leak.
Homes around Longview take a beating from wet winters and older galvanized lines, so we see plenty of failed pans and low water pressure at the shower head. If you have been searching for shower installation in longview WA near me, the fix usually starts with a camera check of the drain line and a pressure test before we quote. We also handle affordable shower replacement longview Washington projects where the goal is a clean, code-correct shower without a full bathroom remodel.
- What it is
- A rebuild of the pan, drain, valve, and waterproofing.
- When it helps
- Leaks, low pressure, cracked tile, or a tub you cannot step over.
- What you get
- A tested, code-correct shower that drains fully.
How our shower installation process works
You get a written scope, a start date, and a daily update. Here is the sequence we follow on nearly every shower replacement in Longview.
Tools and methods we use
Each method answers a different question. Together they leave very little to guess.
Crimps PEX rings for a permanent, leak-free connection on new supply lines running to the shower valve.
Sweats copper fittings when we tie a new shower valve into an existing copper system that is staying in place.
Clears hair and soap scum from the shower branch line before we set a new drain, so the pan drains freely.
Scours the drain line when buildup is heavy, restoring full pipe diameter before the new shower goes in.
When Longview homeowners call us
A 1960s ranch in North Longview has a tub surround with failing caulk and a soft spot near the drain.
The drain gets camera-checked before the pan goes down.
HomesA Downtown Longview homeowner wants a curbless walk-in for aging parents who visit often.
We frame a curbless entry, add blocking for grab bars, slope the floor for drainage, and install a low-profile linear drain.
HomesA rental property near Longview Heights needs a durable shower that survives tenant turnover.
We install acrylic panels over a new pan and valve, which cleans easily and resists chips.
BusinessesA Spring Hill family wants to replace a cracked tile shower without a full bathroom remodel.
The rest of the bathroom stays untouched.
Homes
How shower installation runs in Longview
Longview gets steady rain from fall through spring, and that moisture finds every weak point in a bathroom. Older homes around Downtown Longview and Pine Tree often still have galvanized supply lines, which corrode from the inside and drop pressure at the shower head.
Downtown Longview
Many homes here date to the 1920s and 1930s, with original cast iron drains that need camera inspection before a new pan goes in.
Longview Heights
Newer construction with PEX supply lines, so shower replacements focus on valve trim and waterproofing rather than repiping.
Spring Hill
A mix of mid-century ranches where tub-to-shower conversions are common and floor framing often needs reinforcement for a curbless pan.
- Downtown Longview
- Longview Heights
- Spring Hill
- North Longview
From problem to finished result.
Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.
PhotoLeaking tub surround to walk-in shower
Before: A 1965 ranch in North Longview had a tub surround with failing caulk, a soft spot near the drain, and water stains on the ceiling below. The valve was original and seized on the hot side.
After: The ceiling stain was repaired and the shower passed a 20-minute water test.
Cracked tile shower rebuilt with new pan
Before: A Spring Hill home had cracked tile and a flexing pan that had been patched twice. Moisture had reached the framing behind the valve wall, and pressure at the head was weak.
After: Pressure at the head returned to full flow and the pan drains in under a minute.
Curbless walk-in for easier access
Before: A Downtown Longview homeowner needed a step-free shower for visiting parents. The existing tub had a 17-inch wall and no blocking for grab bars.
After: The entry is flush with the bathroom floor and drains fully after each use.
Shower problems we solve in Longview
Most shower calls start with one of these four issues.
Cracked or flexing shower pan
Water seeps under the pan and into the subfloor, which leads to rot, mold, and a soft spot you can feel underfoot.
Low water pressure at the shower head
A clogged cartridge or corroded galvanized line cuts flow to a trickle.
Leaking valve behind the wall
A dripping valve body soaks the framing and drywall slowly.
Outdated tub you cannot step over
A high tub wall becomes a fall risk and limits how you use the bathroom. It also wastes space that a walk-in shower would use better.
Why homeowners upgrade their shower
A new shower is one of the few home projects you use twice a day.
No more hidden leaks
A failed pan or missing membrane sends water into the subfloor for months before you notice.
Better pressure and temperature
Old valves and clogged cartridges cut flow to a trickle.
Walk-in access that fits
A walk in shower installation longview WA removes the tub wall you have been stepping over.
Cleaner, easier upkeep
Acrylic panels and large-format tile wipe down in minutes compared to grout lines that stain.
What you receive on the job
Clear records you can keep and share.
Written scope
Materials, layout, and pricing before work starts.
Drain camera notes
What the line looked like before the new pan.
Test results
Pressure and flood test readings from the rough-in.
16 years of shower work in Cowlitz County
Longview Riverbend Plumbing has been installing and replacing showers since 2010, which means 16 years of working on the mix of older homes and newer builds…
Drain camera
Shows whether the branch line is clear or has roots and offsets.
Moisture meter
Reads framing and subfloor around the old pan to size the repair.
Pressure gauge
Confirms flow at the valve so the new shower head performs.
Is your longview area covered?
Type your ZIP code or town to check. If you are nearby and not listed, call and ask.
longview ZIP codes
- 98632
Towns we serve.
Based in longview and covering the places around it. Pick one for local details.
What Longview homeowners say
Our 1950s tub surround was leaking into the ceiling below. The crew tore it out, replaced the valve, and set a new pan with a waterproof membrane. They ran water for 20 minutes before they left and showed me the drain slope. Three months later, no stains and the shower holds temperature when the washer runs.
We wanted a walk-in for my father, who could not step over the tub anymore. They framed the opening, added blocking for grab bars, and sloped the floor so it drains fast. The job took five days and they cleaned up every evening. My father uses it without help now.
The old shower had low pressure and a cracked pan. The written quote matched the final invoice, and the bathroom was usable the same day they finished. I have already recommended them to a neighbor.
Frequently Asked Questions
Short answers for the first few minutes. The team can cover the rest.
Still have a question?
Describe what you are seeing and we will point you to the right next step.
(360) 886-3111A simple acrylic panel swap with a new valve sits near the low end. Tile, a curbless pan, or a moved drain pushes toward the top. We give you a written number after the on-site assessment so there are no surprises.
A standard shower replacement takes two to four working days from tear-out to final caulk. Walk-in conversions with framing changes run four to six days. We schedule the rough-in and finish stages back to back so your bathroom is not torn apart for weeks. You get a start date and a daily update on progress.
Yes. We handle shower replacement longview WA for acrylic, tile, and prefab units, including pan and valve upgrades. If the existing drain and framing are sound, we can often keep them and replace only the surround and valve. That keeps the project affordable shower replacement longview Washington pricing without cutting corners on waterproofing.
The wet climate makes waterproofing more important than tile choice, so we focus on the membrane and drain. If you want easy cleaning, acrylic wins.
Related Services
Other services from the same team.
Get your shower installation longview WA quote today
(360) 886-3111Call (360) 886-3111 and we will schedule an on-site assessment, camera the drain, and hand you a written scope with pricing.
Contact Longview Riverbend Plumbing
Call us at (360) 886-3111 or email [email protected]. We answer the phone during business hours and run after-hours emergency calls for burst pipes and sewer backups. Most same-day appointments are booked before noon. Tell us what you are seeing and we will send the right plumber with the right parts.